I was wondering if it is possible to use a RTD instead of a thermocouple with this chip or are there other chips available able to do the same job as the ADS1118 but with a RTD. Thanks for ...

My customer has a question about SD pin. I would be grateful if you could advise. According to the LMH6601 datasheet, p. 20, 7.2.1 Shutdown Capability and Turn On/Off Behavior, If SD_Pin (5PIN) is not ...

Uploads a binary file to the Flash memory, via SPI, then clears the flag and resets Makes the jump to the aplication uint32_t transferAddress; // Address that is ...

I am using ADS1263EVM-PDK. I want to measure current using differential input, voltage across shunt resistor( 1 ohm) . used INA0 and INA1 . i am using GUI tool. the full scale voltage is 5 v , taking ...

I am using PIC32MZ2064DAS169i micro controller with DP83848 PHY. I have interfaced the DP83848 PHY driver library in MPLAB version 6.20 harmony library. When i am ...

I want to use the DTC function of the UCD7138, which is controlled by the UCD3138A, so I need to customize the UCD3138FW_LLC firmware. I would like to add an interrupt process when the CIMINT_ALL_DTC ...

I read the result register for current measurement 1000 times. I found that I got negative value(unit: V), but it shouldn't be like this. here is our pin definition ...

I am using TMS320F28335 DSP for Power electronic application. Following are the scenarios when PWM output is undesired (Short duration pulses): 1. During power on/off cycle. 2. When Power supply ...

exactly same as here, but no way to complete the installation.I also tried to launch orLibraryDownload from the command line, just for test. Here is the result: then, nothing happens.

I define the function, which calls the library functions, to be stored before start in the FLASH and copy during start of the program to RAM. *the function itself is copied to the RAM and the PC goes ...

our soc application need to open "/dev/dma_heap/carveout_edgeai_shared-memories", but in the development board, there is just 'linux,cma' and 'system' node in /dev ...

Note - all references to issuing commands and displaying data refer to the use of BQStudio and an EV2400. Also just to provide context, I have a BQ27520EVM connected to a BQ41Z50EVM, and my ultimate ...